8/3/2023 0 Comments Audulus requirements![]() But I also have my compressor pedal and a fuzz. I have two Pulp Logic CTACT 1U tiles for input/gain staging, and I find they are extremely useful for many different applications – just getting more juice out of things. This is a good example of something that is a little higher end. I’ve bought one Little Mikey, which I can’t say enough good things about Excited for you I am excited for the coming dormant season. ![]() Some people make some choice about spending thousands and thousands and all that. You take 3 or 4 years to fill out your whole plan. Then just don’t buy “beginner” or “entry” products and stay away from anything that is “a good deal.” You basically have to go about it like the kid who needs the real skateboard, not the sale board. That takes care of that financial problem. That is just to say, and it is too late for everyone I am sure: Don’t but an audio interface, buy an ES-8 or ES-9. But then it starts to climb as the features come in. I am mentioning this to anyone reading, because the question about an additional interface came up.Īudio interfaces are expensive. There is a way to go about all this where you don’t have to spend so much if you know what to buy in which order. I’d been going back and forth about an ES-8, and hoping it would be available to purchase at some point, and then this just popped up in my feed. The ES-9 has a set of line level outputs so it shouldn’t be as necessary to adjust audio gain depending on your setup. The ES-8 outputs are capable of producing an audio output that’s compatible with Eurorack but the level is a bit high for standard line level so audio gain also need to be adjusted at times. For example my Model D uses +/-5 volts for CV modulation but the ES-8 is capable of +/-10 volts so I scale the input from Audulus down to avoid exceeding the 5 volt limit. It’s also sometimes necessary to scale or offset other CV signals. ![]() Since there isn’t a common standard for the 0 reference in VPO and tracking varies a bit between manufacturers, the Audulus modules allow you to match Audulus output to your particular synth and correct for any variation in VPO tracking. This is particularly useful for converting the 1 per octave pitch signal commonly used in Audulus to a volt per octave signal for use with Eurorack style hardware. The ES-8 related modules posted on the forum are there to allow you to adjust the input to the ES-8 so that the resulting output voltages are properly scaled and offset for the hardware you’re connecting to. Because they are DC coupled it is possible to send low frequency and static voltages through the interface. At the most basic level you can treat them as you would any other audio interface with one important exception. ![]() The MIDI in the ES-9 is also class compliment and requires no special drivers for macOS or iOS. It’s definitely on my wish list as well.Īs far as interface modules are concerned, since both the ES-8 and ES-9 are audio interfaces, no special interface to Audulus is necessary. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |